Modern Pipe Solutions has served residential homeowners in San Diego and Southern California for over 20 years
MPS specializes in the following services:
• Sewer Inspections
• Cleaning and Repairs
• Sewer Pipe Lining
• Trenchless Sewer Repair
• Roof & Storm Pipe Sleeving
• Roof & Storm Pipe Cleaning
• Roof & Storm Pipe Lining
• Leak Detection Service
• Plumbing Water Trenchless Pipe Repairs
A home is one of the most expensive purchases you will make in your lifetime. It’s important to have peace of mind knowing that if you run into any plumbing issues, you have a professional team you can rely on to get the job done right.
Residential Experience You Can Count On
MPS has over 20 years of trenchless sewer repair experience helping homeowners find a Modern
Solution to their sewer pipe problems.
Our inspection process can give you the information you need regarding roots, cracks, leaks, and the cause of your backed-up plumbing. Our pipe cleaning and pipelining technologies can be a cost-saving and less destructive solution for your home so that we can get you back to what’s important to you.
Traditional replacement inside and outside the home can be costly and unnecessary.
Sewer & Drain pipes have a lifespan of 35-45 years and can cause major problems over time. Corrosion and roots break down and clog these pipes and can cause backups, leaks, and floods in your home.
Avoid these problems and find a Modern Solution like pipe lining, pipe sleeving, trenchless sewer repair and by calling us before they happen.
• Homes built before 1980
• Gurgling & bubbling toilets
• Slow drains
• Frequent back ups
• Sewer odors
• Warped & wet floors
• Wrinkled & bubbled paint on floors, ceilings, and walls
MPS Is A Certified Nu Flow Installer With Over 20 Years Experience
-
Clean
First, MPS will de-scale corroded, root-intruded pipes back to their original diameter. The cleaning process is essential to ensure that the epoxy-saturated liner creates a permanent and leak-free bond with the host pipe.
-
Install
Next, MPS will install an epoxy-saturated liner that is pulled into place through new and existing
access points. An internal rubber bladder is then inflated, pressing the liner assembly against the
inner side wall of the pipe. -
Repaired
MPS will then allow the epoxy-saturated liner to cure fully. This process only takes a few short
hours. Finally, the bladder is deflated and removed, leaving a tight, seamless, and clean pipe within a pipe.